Author Topic: 2 PBX single CAM  (Read 16533 times)

justzikle

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 6
    • View Profile
    • Email
2 PBX single CAM
« on: October 20, 2008, 01:05:01 AM »
We have two Nortel PBX (11c) installed in a building. Can we use CAM to capture both PBX CDR data for billing?

cegonzalez

  • Newbie
  • *
  • Offline Offline
  • Posts: 2
    • View Profile
    • Email
Re: 2 PBX single CAM
« Reply #1 on: November 12, 2008, 05:33:38 PM »
We have two Nortel PBX (11c) installed in a building. Can we use CAM to capture both PBX CDR data for billing?


We have the same question , can we use it? or can it be instaled as a second service for the other?

cegonzalez

  • Newbie
  • *
  • Offline Offline
  • Posts: 2
    • View Profile
    • Email
Re: 2 PBX single CAM
« Reply #2 on: November 12, 2008, 06:01:19 PM »
 ;) we just add another comunication port with diferent IP and Port .
Good luck

Administrator

  • Administrator
  • Super User
  • *****
  • Offline Offline
  • Posts: 171
    • View Profile
Re: 2 PBX single CAM
« Reply #3 on: September 10, 2009, 10:21:31 AM »
It depends on how far the phone systems are from the CAM computer. If they are close then you may be able to use it with a single CAM license. If they are located more than 200 feet apart you will either need line drivers or you will need to purchase a second CAM license. Since CAM is a web based product you can run reports from any computer in the office connected to the same network. Just simply start internet explorer and enter the IP address and of the CAM computer (followed by its webserver port number if its not 80).